ZINST-EK1218072 ASSEMBLY INSTRUCTIONS TO FULLY ENCLOSE 12’ X 20’ (ROOF) X 7’ 2”SQ VERSATUBE CLASSIC CARPORT WITH 8’ X 7’ GARAGE DOOR PAGE 1 REV 2/11
PAGE 10 INSTALLING TRIM ON THE GARAGE DOOR FRAME ANGLE TRIM INSTALLATION: Cut two pieces of Angle Trim to fit from the concrete slab to the top of t
PAGE 11 INSTALLATION OF J-TRIM AROUND GARAGE OVERHEAD DOOR: Top J-Trim: Attach one 8’ piece of J-Trim to fit from the bottom of the sheeting ledge to
Step 1: Cutting panels for both sides of door The four panels to be attached on both sides of the door will be cut from the 8' panel provided. Us
INSTALLATION OF SHEET METAL PANELS ON THE SIDE OF BUILDING (8) 9’-2” panels on an 18’ long x 7’ side wall frame. These instructions assume that the
INSTALL CORNER TRIM Before you install the corner trim you must install Outside Foam Closures. The foam closured are grey foam strips with notches cu
INSTALLING YOUR GARAGE DOOR IN A VERSATUBE FRAME Note that the Versatube frame is all steel with no overhead ceiling joist. You must deviate from the
Step 5 Installing Additional Door Sections Follow the door manufacturer’s instructions and assemble door section 2. Note that each door section uses a
#12 x 3/4” PAINTED SELF-DRILLING SCREW WITH RUBBER WASHER EYE HOOK WITH 2 LOCKING NUTS PROVIDED WITH GARAGE DOOR (HOOK FOR SPRING) RAFTER 5/16” X 3/4
INSTALLING THE TOP DOOR SECTION With the door tracks (and low headroom kit if required) installed it is now time to install the last or top door sect
SAFETY, HAZARD and MAINTENANCE INSTRUCTIONS CAUTION: Read the following safety warnings and all instructions in their entirety prior to installation.
ATTENTION: IT IS IMPORTANT THAT YOU READ THE FOLLOWING NOTES BEFORE STARTING THE ASSEMBLY OF YOUR SHELTER NOTE: If you are not mounting the shelter to
BACK ENCLOSURE FOR 12’ X 7’ HORIZONTALLY SHEETED GARAGE PARTS LIST PART NO. PARTS QTY. LETTER 71-BE-T T-SECTION 1 A 7400-5875 BASE RAIL 2” X 2
ASSEMBLY INSTRUCTIONS FOR BACK ENCLOSURE FRAME BE-12-7.0 (12' WIDE) STEP 1: BASE RAIL ASSEMBLY Loosely assemble a base rail (B) on both ends
INSTALLATION OF SHEET METAL PANELS NOTE: IF YOU PURCHASED A BACK ENCLOSURE, THE BACK ENCLOSURE PANELS MUST BE INSTALLED FIRST. INSTALLATION OF BACK E
FRONT ENCLOSURE FOR 12’ X 7’ HORIZONTALLY SHEETED GARAGE ON A GARAGE THE FRONT ENCLOSURE IS ASSEMBLED TO THE FRONT FRAME SECTION. PART NO. PART QTY.
ASSEMBLY INSTRUCTIONS FOR FRONT ENCLOSURE FRAME FE-12-7.0 (12 WIDE) STEP 1: Assemble Front base Rails and L-Sections Assemble the Front Base Rails
STEP 3: Assembling Door Verticals Place one Door Vertical (C) on to one L-Section (D). Square the Door Vertical Tube With the building by measuring an
Kommentare zu diesen Handbüchern